Product Release: INS-U - GPS-Aided Inertial Navigation System

Inertial Labs Releases the INS-U, a Low-Cost, U-Blox Based GPS-Aided Inertial Navigation System with Air Data Computer (ADC) Output Signal

The new INS-U a fully integrated INS, Attitude & Heading Reference System (AHRS), Inertial Measurement Unit (IMU), and ADC high performance strapdown system that determines position, navigation, and timing (PNT) information for any device on which it is mounted.

Paeonian Springs, VA: Part of Inertial Labs’ new generation of GPS-Aided INS solutions, the INS-U utilizes a single antenna, multi-constellation U-Blox GNSS receiver. With access to GPS, GLONASS, Galileo, QZSS, and BeiDou, the INS-U can be used in a variety of GPS-enabled environments and is protected against spoofing and jamming. Additionally, the INS-U is comprised of two barometers, a miniature gyro-compensated fluxgate compass, and tri-axis temperature calibrated advanced MEMS accelerometers and gyroscopes. These high-performance sensors, along with Inertial Labs’ new on-board sensor fusion filter, state of the art guidance and navigation algorithms, provide accurate position, velocity, and orientation of the device under measure.

Perhaps the most defining feature of the INS-U is its embedded ADC. An essential avionics component for modern UAV applications, an ADC outputs static & dynamic pressure, pressure altitude, calibrated & true airspeed, true angle of attack, rate of climb, and wind speed of the device under measure. This data, combined with inertial reference information, provides UAVs with accurate information about the unit and its relation to its environment.

By utilizing data from an INS, AHRS, IMU and ADC, the INS-U provides a complete navigation solution for UAV and Helicopter applications. The unit can use time-of-flight (ToF) aiding data from a ground station for long term GNSS-denied conditions as well as external position and heading so it can still output accurate PNT information regardless of the environment. The INS-U is a lightweight and compact solution with dimensions of 82 x 40 x 26 mm and a weight of less than 200 grams. This, along with an IP67 environmental enclosure, ensures that the INS-U can fit the environmental requirements and size and weight restrictions of a wide range of applications.

With over 20 years in the positioning and orientation sensor industry, Inertial Labs is growing its catalog of innovative solutions at the best value, smallest size, and lowest power consumption in their class. From commerce and industry to government, defense, and aerospace, Inertial Labs is at the forefront of developing and customizing products for exciting technologies, solving today’s problems, and unraveling those of tomorrow.

About Inertial Labs

Established in 2001, Inertial Labs is the leader in position and orientation technologies for both commercial/industrial and aerospace/defense applications. With a worldwide distributor & representative network covering 25+ countries across 6 continents, a standard product offering that spans from Inertial Measurement Units (IMU) up to full GPS-Aided Inertial Navigation Systems (INS), and an application breadth that covers Land, Air, and Sea; Inertial Labs covers the gambit of inertial technologies.

For further information contact:

William Dillingham, Application Engineer
Will.Dilingham@inertiallabs.com
+1 (703) 880-4222
Inertial Labs Inc,
39959 Catoctin Ridge Street, Paeonian Springs, VA 20129
www.inertiallabs.com

Trademark Legal Notice: All product names, logos, pictures, and brands are property of their respective owners. All company, product and service names used in this document are for identification purposes only. Use of names, logos, pictures, and brands does not imply endorsement. Mentioned or referenced industries are trademarks of its affiliates or its respective owners, registered in many jurisdictions worldwide.